1
User Zone / BMC console com2 on Talos II
« on: June 07, 2023, 02:36:47 pm »
Hello, I've got one of these TTL/USB serial adapters that are suggested in the wiki and am
able to get output at 115200bps 8n1 which appears to boot up the BMC. Unfortunately I don't seem
to be able to interrupt the boot process by "pressing any key" nor able to login. I've tried setting
and unsetting software flow control to see if I can get any input.
The cable is pretty simple, TXD/RXD and GND. I am not using the power lead (it shouldn't be necessary).
Is there something else I should be doing?
able to get output at 115200bps 8n1 which appears to boot up the BMC. Unfortunately I don't seem
to be able to interrupt the boot process by "pressing any key" nor able to login. I've tried setting
and unsetting software flow control to see if I can get any input.
The cable is pretty simple, TXD/RXD and GND. I am not using the power lead (it shouldn't be necessary).
Is there something else I should be doing?
Quote
DRAM Init-V12-DDR4
0abc1-4Gb-Done
Read margin-DL:0.3470/DH:0.3470 CK (min:0.30)
U-Boot 2016.07 (Mar 17 2021 - 04:57:57 +0000)
Watchdog enabled
DRAM: 496 MiB
Flash: 32 MiB
In: serial
Out: serial
Err: serial
Net: aspeednic#0
Hit any key to stop autoboot: 0
## Loading kernel from FIT Image at 20080000 ...
Using 'conf@aspeed-bmc-opp-talos.dtb' configuration
...
[ OK ] Started OpenBMC Software Update Manager.
[ OK ] Started OpenPower Software Update Manager.
[ OK ] Started Phosphor SNMP conf Manager.
[ OK ] Started Phosphor Network Manager.
[ OK ] Started Wait for /xyz/openbmc_project/state/chassis0.
[ OK ] Started Phosphor Ldap config updater.
[ 66.758448] ftgmac100 1e660000.ethernet eth0: Set package 0x0, channel 0x0 as preferred
[ 66.769830] ftgmac100 1e660000.ethernet eth0: NCSI: No channel with link found, configuring channel 0
Phosphor OpenBMC (Phosphor OpenBMC Project Reference Distro) 0.1.0 talos ttyS4
talos login: