Software > User Zone
Void Linux thread
Hasturtium:
I have tried - it just seems to time out. The BMC isn’t holding onto 192.168.1.1 for the gateway IP. I can set it to any other arbitrary IP, but if I set it to 192.168.1.1, it resets to either 0.0.0.0 or the last arbitrary IP I set. I’d like to not have to put in a support ticket, but we will see.
MPC7500:
How did you set the IP address?
Normally the BMC is receiving automatically the IP via dhcp.
https://svennd.be/set-ipmi-to-use-dhcp/
Hasturtium:
I followed the directions in the link to setup the BMC password for the first time, then used the .42 address to connect. If that’s not the correct IP address, let me know.
ClassicHasClass:
If you're directly wired together, the gateway IP can be 0.0.0.0 because the only other host is your client. I don't think that's your problem. Since you know the MAC address for the Blackbird, I suppose you could forge an arp entry (arp -s).
Hasturtium:
Just tried that, setting arp for the server/Blackbird’s IP address directly to the Blackbird’s MAC address on the MacBook Pro client, and it’s still timing out. As below:
sudo arp -a 193.168.0.42 [the Blackbird MAC address]
edit: Also repeated the client steps for a USB thumb drive install of Ubuntu booting on my Windows machine, following the Talos II Quick Start directions again. That version of SSH is at least polite enough to indicate that it finds no route to the host in a shorter period of time than macOS's timeout. I don't suppose I need to supply it with a specific port...?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version