Software > User Zone
Void Linux thread
MPC7500:
I guess you're on BMC firmaware v2.0 you could easily sync the time via NTP on the BMC GUI. Should be straight forward. Or login into BMC and activate the NTP service.
Hasturtium:
I have been beating my head against these instructions, using an ethernet adapter for my 2015 MacBook Pro and the default mac install of ssh:
https://wiki.raptorcs.com/wiki/Talos_II_Beginner%27s_Quick_Start_Guide
Both systems are disconnected from any means of internet connection except the crossover ethernet cable connecting the Mac directly to the BMC-shared ethernet port on the Blackbird. The Blackbird does not want to hold on to the provided gateway IP address, dropping it after a few seconds and ipmitool reporting a gateway IP of 0.0.0.0. I've tried other arbitrary gateway IPs which ipmitool indicates are held, but after using ifconfig to manually set the IP and netmask for the Mac's en3 interface, ssh reliably times out trying to connect to 192.168.0.42. Also no luck trying to visit https://192.168.0.42 with any web browser installed in the system.
What am I missing?
atomicdog:
What BMC version do you have? did you see this in the quick start...?
--- Quote ---Please note that older releases of BMC firmware had an issue where the IP could not be set. If you run the commands listed below but the IP information does not change (and you cannot work with the factory defaults), upgrade your BMC as explained in https://wiki.raptorcs.com/wiki/Talos_II/Firmware.
--- End quote ---
Hasturtium:
It’s version 2.00, so this shouldn’t apply…
MPC7500:
Just type the IP address of the blackbird in a browser to reach the GUI.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version