Third Party Hardware > GPU Compute / Accelerators

Necessary firmware for Navi14

<< < (6/6)

power9mm:
If i'm unable to get the gpu to work via this method would i be able to use a jumper on the AST and have the gpu function without flashing firmware?

MPC7500:
This will give the same result. But try it. If you set the jumper you will get a black screen at the beginning and the keyboard will not work, IIRC until the OS is loaded.

AST is connected via HDMI?
AMD via DP?

If yes, boot to petitboot.
Switch to DP.
Press enter

power9mm:
I dont have a jumper on hand atm unless i want to pull one off the board which im not going to do. This is what i got when i tried running startx under leap.

I went back to leap after i determined it wasn't a distro specific issue.

worse case scenario, i can flash amd firmware and use the jumper, correct? Would've really preferred not to do that but i'm at a loss at this point

power9mm:
update: got it to work, had to do the xorg conf file in mentioned in the previous page.

Navigation

[0] Message Index

[*] Previous page