Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MPC7500

Pages: 1 ... 19 20 [21]
User Zone / Petitboot AST2500: Maximum resolution?
« on: December 06, 2019, 11:40:57 am »

while booting I have in Petitboot with AST GPU a resolution of 800x600. Is there a way to change the resolution (e.g. to 1080)? If yes, how?

Talos II / Re: Talos User's Survival Kit/New Talos User's Shopping List
« on: November 29, 2019, 05:59:50 pm »
But if you want to update the FPGA firmware, you have to use a SPI programmer.

User Zone / Re: Void Linux thread
« on: November 29, 2019, 09:47:13 am »
That's why Raptor is unable to build a notebook at the moment.

...and an open-firmware DRM-free GPU.  That's the primary hold-up for us right now, not the CPU.


Condor / Re: Technical features
« on: November 28, 2019, 10:26:37 am »
This is all we know so far, AFAIK:

Applications and Porting / Re: Suggestion: BOINC -> Seti@home (sah)
« on: November 26, 2019, 04:50:26 pm »
Hello  :)

Unfortunately, I cannot answer the second half of the question. But in the past Alex Kan (he worked for a certain fruit company) had optimized clients for G4 and G5.

After the switch we could annoy (because of the PPC970MP ;)) Intel a little bit -> Top Computers February 2006

I just found the old directory of this client.

This client was in use at least until 2009, AFAIK.
I'll keep looking, maybe I'll find more.

Perhaps it does for the first attempt a quick and dirty optimization?
RCS Wiki <- for the sake of completeness only ;)
Easier Power ISA vectorizing for fun and profit with GCC x86 intrinsics ;)

Edit: Here is the client from 2008, but sadly without source.

Applications and Porting / Suggestion: BOINC -> Seti@home (sah)
« on: November 26, 2019, 03:05:36 pm »
Hello to all,

It would be nice if there was an optimized Seti@home client again.

The source code is here, AFAIK:

General OpenPOWER Discussion / Re: Ahoy shipmates!
« on: November 25, 2019, 06:37:12 am »
Hello to all!

Good to have a forum :)

Pages: 1 ... 19 20 [21]