Raptor Computing Systems Community Forums (BETA)
Raptor Computing Systems Hardware => Blackbird => Topic started by: power9mm on January 21, 2023, 02:13:20 pm
-
does "1" mean its enabled? and is that film on them a tamper protection?
https://imgur.com/j9cXkwW.png
-
The film (kapton tape) is there to protect the switch when it's being soldered to the motherboard add to allow a machine to pick up the part and place it on the motherboard.
-
so which setting enables write protection? I assume it's 1, but I want to be sure. I haven't seen it documented specifically.
-
Looking at the schematic, moving the switch towards 1 disables write protection (allows writing).
The pin is disconnecting from BMC control and pulled high by resistor; 1(off) 2(on)