706
User Zone / Re: Graphics Card install
« on: December 05, 2019, 08:39:27 am »
ok thanks, in any case I'll try to write directly to AMD to let him know this problem, I want to see what they answer me ...
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
707
User Zone / Re: Graphics Card install
« on: December 05, 2019, 03:21:43 am »
tell me exactly where I have to write, the address of the AMD support that takes care of the drivers, I have to tell them that the drivers currently in use have bugs that do not allow the correct functioning, to fix the bugs so that they can use the their 5700 cards without problems ... am I right?
708
User Zone / Re: Graphics Card install
« on: December 05, 2019, 12:54:11 am »
are you even telling me that maybe we will never have adequate support on the 5700s? This is a serious thing though ... honestly I'm not sure now what to do ... I might first try writing to AMD for clarification, who knows if they can give me some advice ... it would be a shame not to be able to use it after spending 500 euro and even if it is returned cmq a great sin ...
709
User Zone / Re: Graphics Card install
« on: December 04, 2019, 12:31:38 pm »
but instead I was also thinking about the procedure that Raptor published on Wiki but I didn't understand. This is the configuration of the Xorg.conf file, the procedure that allows you to activate the graphics card via Xorg you can post it in detail as you did with that of the petitboot? I would like to understand if it is possible through that to activate the GPU ...
710
User Zone / Re: Graphics Card install
« on: December 04, 2019, 06:46:23 am »
no I personally no, since you are more competent in the matter, see if you can understand how to communicate these problems to them. What I would like to understand instead is, AMD only develops for X86 as a rule, how do you request drivers for Power? Also on the site there are only those for X86 ... Maybe they release the source code because they are open source and then someone then develops the drivers for Power or what?
711
User Zone / Re: Graphics Card install
« on: December 04, 2019, 01:25:07 am »
ok Merklort then at this point I stop and wait for you to have more information and possibly something correct before doing any operation, with my very little Linux experience I can't do much ... I stay connected let me know thanks
712
User Zone / Re: Graphics Card install
« on: December 03, 2019, 02:26:35 pm »
the monitor that I currently use correctly works on both the HDMI ports it has, so I don't think it's monitor. The Blackbird itself works regularly via HDMI on this monitor so I don't think it's monitor. You should explain to me then the procedure to get this Xorg better because I don't know it unfortunately. Some advise me to wait for the kernel in version 5.4, they also tell me that the next Blackbird firmware will allow to enable the card from the beginning ...
713
User Zone / Re: Graphics Card install
« on: December 03, 2019, 01:48:29 pm »
the dmesg I published in the previous posts, if you go backwards in the first or second page, you find my post with the whole report of the dsemg that I did attached ... You guys didn't answer me anymore after I told you that that change on the topic in the line at the start of Linux does not work ... What news do you give me?
714
User Zone / Re: Graphics Card install
« on: December 02, 2019, 02:35:22 pm »
guys nothing to do, I removed quiet and rhgb, exactly after swap I entered the line, I started but nothing does not work and hangs exactly like before when I sent the photo ...
715
User Zone / Re: Graphics Card install
« on: December 02, 2019, 02:16:55 pm »
yes the connection I already prepared some days ago because I realized that disables the HDMI output of the Blackbird in fact when it is blocked I selected the second output of the monitor where there is connected the HDMI output of Redeon but nothing was black ... Now I try to eliminate those 2 topics and let you know ...
716
User Zone / Re: Graphics Card install
« on: December 02, 2019, 01:43:45 pm »
guys then I tried to insert the topic, wanted to start but it got stuck in the upload ... only that I'm doing all this without having yet touched anything on the Blackbird, I ask you to confirm if I always have to insert that jumper in the motherboard anyway , before executing this procedure ... otherwise if I don't have to then nothing doesn't work ...
717
User Zone / Re: Graphics Card install
« on: December 02, 2019, 10:05:18 am »
Ok thanks, i try in this mode. as soon as I did I let you know the result, now I'm still at work, this evening Italian time of course, I'll try and write as soon as I get the result ...
718
User Zone / Re: Graphics Card install
« on: December 02, 2019, 07:37:53 am »
this is the wording that my system carries, where should I put the line you tell me? Second question, should I put it the same as the one I read in your example or should I just put the modprobe blacklist part?
719
Blackbird / Re: HDMI output for mother board
« on: December 02, 2019, 07:25:45 am »
no I was talking about the Blackbird motherboard being in Blackbird's discussion, the AMD GPU still failed to activate it, we're working on it. I'm talking about Blackbird's HDMI output and Raptor confirmed to me that there is a problem in the BMC firmware ...
720
User Zone / Re: Graphics Card install
« on: December 01, 2019, 04:49:27 pm »
he tells me he can't find the kernel startup argument because I added the line, the photo doesn't let me post it because he tells me that there is a 128k limit
