Software > User Zone
Graphics Card install
MPC7500:
If I C&P this line from the wiki: git clone git://git.kernel.org/pub/scm/linux/kernel/git/jwboyer/fedora.git --depth 1 --branch kernel-5.5.0-0.rc1.git0.1.fc32
I get:
--- Code: ---...
remote: Enumerating objects: 70582, done.
remote: Counting objects: 100% (70582/70582), done.
remote: Compressing objects: 100% (67516/67516), done.
remote: Total 70582 (delta 5378), reused 29135 (delta 2240)
...
--- End code ---
MauryG5:
ok then I'll do as you say, I copied the exact line but it is possible that I made some mistakes that I didn't see. Thanks for your clarification MPC, I try and let you know
MauryG5:
Guys then, I'll update you on the procedure, MPC you were right, obviously I was wrong to write some characters and didn't take the commands, I did the copy and I managed to make some commands operational. However unfortunately arrived at the command user @ bb fedora] $ cp /boot/config-*.ppc64le .config, the system returns me error telling me: cp: the objective '.config' is not a directory
I have always done the copy paste exactly as for all the commands up to here carried out and gone to good time ... How come now it gives me error and doesn't make me continue? Where the hell is the mistake this time? :(
MPC7500:
I hope you insert the line without the dollar sign? ;)
MauryG5:
I admit not being practical on linux by now you all know it, but some things I still know I can distinguish ... no, I had even tried to write it directly to the command but nothing always knows the same error to me ... :(
MauryPower9 @ localhost fedora] $ cp /boot/config-*.ppc64le .config
cp: the target '.config' is not a directory
[MauryPower9 @ localhost fedora] $
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version