Software > User Zone
Graphics Card install
MauryG5:
Guys, thanks to everyone for the advice, unfortunately I can't complete the operation, I cleaned up the older kernels and maybe some files went away, I don't know why I saw that I cleaned up the old ones without touching version 16 but in anyway now it gives me error when i run the command: make oldconfig that didn't give me before. I broke down and directly installed the ready-made kernel Merklot had given me. Now to see if you enable the graphics card I could make the changes on Xorg.conf.d but I can't get into it. The directory is already there, I should just make those changes to activate the card and I would like to keep both HDMI outputs active or both the graphics inside the Blackbird and if possible finally, that of the AMD Radeon Navi 10 graphics card. Can you tell me you how to do it since from the wiki guide I can't understand how to do it? Thank you
MPC7500:
I don't know what command you executed. I don't know what kind of error you got.
MauryG5:
At the moment, let's leave the mistake alone, I'll post it to you later. I'm interested in knowing now how to open and fix the Xorg.conf.d file to tell the system that there are 2 GPUs and that it must use both. To open the file I wanted to understand in the meantime if I can always use the command "sudo gedit /etc/X11/xorg.conf.d or I have to use other. Then what to put for the system to use both GPUs ...
MPC7500:
https://wiki.raptorcs.com/wiki/Enabling_Navi_10_On_Fedora_31#Configuring_The_Display
AST: At boot (connecting through ssh or a second display
AMD: On desktop
MauryG5:
MPC so you are not telling me anything, I had already consulted that guide but I did not understand practically anything in particular ... I would like to understand if I have to open that file I was talking about above, if I have to do it via the "sudo gedit" command and what exactly do I have to put in to tell him that I have 2 GPUs to use ... this is my problem now ... I installed the ready-made kernel that posted Meklort so in theory it should be enough just to enable the card and that's it ...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version