Software > User Zone

BMC console com2 on Talos II

<< < (2/4) > >>

ClassicHasClass:
Just turn off flow-control entirely. You can get it working later.

atomicdog:
PuTTY doesn't work with some devices because the line ending type is hard coded. You can change it in TeraTerm though, so I would try different setting for CR/LF in TeraTerm.

twenex:
OK, flow control is off, and I'm using TeraTerm with CR+LF with transmit,
no luck.  I'm going to order another unit, as now that I think of it when it arrived it was
"open box" but I didn't think much of it at the time.

atomicdog:
Sorry, I don't know if CR/LF is the correct setting, just meant you should try different ones.

You can also connect the TX and RX together on the dongle and see if you get what you type to loop back.

twenex:
You're right, connecting TX to RX in loopback is simple enough to show that the USB adapter is working properly.
Meanwhile a second adapter arrived which was new and behaves the same way.  Basically, connect the adapter, open a TeraTerm session, apply mains power and watch it boot up.  Input from TeraTerm (with or without CR, CR/LF on transmit) isn't making it and when it gets to the Talos login: prompt input continues to not make it.

If I press the soft power after the BMC gets to the login: prompt the machine will attempt to IPL and display on the VGA port, but gets to a point where no progress is made.

I also have LAN1 on ethernet where it could DHCP, but I'm not seeing any requests.

Navigation

[0] Message Index

[#] Next page

[*] Previous page