Raptor Computing Systems Hardware > Blackbird
Question about firmware flash switches
(1/1)
power9mm:
does "1" mean its enabled? and is that film on them a tamper protection?
https://imgur.com/j9cXkwW.png
atomicdog:
The film (kapton tape) is there to protect the switch when it's being soldered to the motherboard add to allow a machine to pick up the part and place it on the motherboard.
power9mm:
so which setting enables write protection? I assume it's 1, but I want to be sure. I haven't seen it documented specifically.
atomicdog:
Looking at the schematic, moving the switch towards 1 disables write protection (allows writing).
The pin is disconnecting from BMC control and pulled high by resistor; 1(off) 2(on)
Navigation
[0] Message Index
Go to full version